August 21, 2017 was a big day for most of the country with a very rare total solar eclipse visible across much of the country.
In Cary, North Carolina, we only achieved about 95% of totality, but it was still an opportunity to test some basic optical principles and photography skills. So I set up a pair of 10x power binoculars as a projector and was pleasently surprised at the details I was able to photograph.
Solar eclipse, first shot
Even from the first photograph, a line of sunspots could be seen across the orb. The gear is nothing special. All of these photographs are of the image projected through the binoculars onto a white piece of paper and are taken with a Nexus 6 smart phone.
About half way to totality, a strange redness in the sky was obvious to several of us observing the event. Despite the short shadows from the midday solar position, the sunlight appeared as if at the end of the day. A significant diminishment of the radiative energy was obvious, too, and everything felt much cooler despite the continued glare.
Solar eclipse at maximum
2:44pm was the maximum pnuembra (shadow) for the photograph above. You can barely see the last sunspot grazing the edge of the moon's edge.
Solar eclipse photography setup
This was a five minute setup. The binoculars were screwed onto a cheap tripod and a large piece of foamcore board was hurridly cut to fit over the objective ends to create a shadow on the observation board. Gentle re-adjustment from time to time re-centered the image to maintain maximum focal clarity. This photo is from early in the event, and we later adjusted it to place the observation board on the ground so the projection was larger and focus more finely adjusted. (The golf umbrella and chair in the background were never used, the event was too exciting to sit down!)
Solar eclipse shadows
Shadows during solar eclipses are curious. Tiny openings between the leaves of trees act the same way the binocular setup works and effectively project the sun's image onto the ground. The only difference is that the binoculars use lensees to magnify the image with a short focal length and the tree "pinholes" magnify the images according to the proportion of distance of the hole to the ground.
Map of the Triangle, North Carolina (click to open in Google Maps)
The region is technically the bi-polar metropolitan area, Raleigh-Durham, but the Triangle is conceptually defined by corners located at three important landmarks. These mark the major educational institutions at the foundation of the original idea: the Chapel at Duke University, the Old Well at the University of North Carolina, and the Memorial Bell Tower at North Carolina State University.
The economic development area now known as the Research Triangle Park was the brilliant idea in 1954 to transform North Carolina from an agricultural economy to a technological one. The North Carolina population had nationally low income levels, education was weak, and the higher institutes of learning were disconnected. Inspired as a “golden triangle of research” by developer Romeo Guest, the effort to improve the state across many levels grew through the joint efforts of interested and notable citizens, including Wachovia Bank president Robert Hanes, governor Luther Hodges, Brandon Hodges, UNC president William Friday, and sociologist George Simpson.
Paul Rudolph’s Burroughs Wellcome building
In 1959, the Research Triangle Institute began out of the joint UNC/NC State Institute of Statistics on the same site it occupies today. Chemstrand’s high tech facility opened in 1960 and illustrated the logical transition North Carolina needed to make from its textile manufacturing roots. More tenants and facilities grew with the US Environmental Health Center (now NIEHS) in 1965, IBM’s purchase of 400 acres three months later, and the iconic Burroughs-Wellcome facility by Paul Rudolph in 1970, which was completed two years later.
The video below was produced in the early 1990’s promoting RTP and has about 30 minutes of good background on the birth of RTP and interviews with some of the important players. Look past the styles and production quality and watch the most applicable portions from 6:32–37:51.
As an architect, I find these influences interesting because they established the drive in the state to progress. This propelled architecture in the area as well, and the interest to become modern dictated local building style. A multitude of notable examples of modernism were created in the region, such as the Dorton Arena completed in 1952. Numerous houses and the NC State School of Architecture building by George Matsumoto still exist, as well as more homes by other recruits of the long time dean of the NC State architectural school, Henry Kamphoefner, himself of midwest modern influence.
Today is the winter solstice! It’s a time for optimism—from here on, the days will be getting longer.
At 12:11pm EST today, the precise time of the winter solstice, the sun angle is more than 45 degrees lower than on June 21, the summer solstice. Because of this angle, it goes below the horizon earlier than on any other day. Today will be almost 5 hours shorter than the summer solstice.
These two simple factors, the sun angle and the length of day, have impacted building design since Woodhenge (Stonehenge’s little brother). I’m probably a bit of an astronomy fan because of it. The solstice reminds me of extremes, how buildings are deprived of heating sunlight during cold winters and subjected to an enormous amount of heating radiation during hot summer days. The astronomical reality makes quite the impact on energy usage and utility bills during both seasons. Especially when it isn’t considered.
Fortunately, we can design the building envelope to use solar angles in our favor. Simply considering them can both inform design, make more comfortable spaces, and save energy. Since the passive energy design studio I took from John Nelson at UNC Charlotte back about 1988, it is interesting to see this correlation play out in practice. I strongly recommend Sun, Wind, and Light: Architectural Design Strategies by G. Z. Brown for anyone interested in an introduction to these environmental design concepts.
As a personal example, aiming a heavy brick screen with small punched windows toward the southwest in my design of the medical office building resulted in HVAC equipment an entire size smaller. So it saved money on the construction of the building as well as all future cooling costs. Plus the smaller windows reduce the southern glare for the occupants inside. That’s a lot of wins without any drawbacks just by considering the sun at the beginning of design.
Today makes a great day to illustrate exactly how low the sun really is—with an accurate sundial. The typical sundial can be inaccurate up to one or two hours depending on several factors. So I designed one inspired by the Brown book1.
Triangle Sundial at Winter Solstice
In the instructions below is a specially tuned sundial you can download. It is tuned precisely to the center of Raleigh-Durham. (Technically, Latitude 35.8° and Longitude -78.8°, exactly at the Raleigh Chinese Christian Church in Cary, on Hwy. 54 just west of NW Maynard Rd.)
It is also tuned to the wobble of the earth, which varies the shadow of sun quite a bit throughout the year. As you can see, the curve of the red and magenta lines indicates this correction. (If it didn’t wobble, these would be straight lines.)
This sundial is also based on standard local time, meaning it is adjusted to Raleigh-Durham for the sun’s position within the entire width of the Eastern Time Zone. (Which extends from Maine to Western Michigan.)
Finally, it is set to Eastern Standard Time. The United States has been adopting some form of clock adjustment since World War 1 in the implementation of Daylight Savings Time. This means that from March 9 and November 2 you’ll have to add an hour for the dial to read correctly.
One final tip: For accurate readings, the sundial must be dead flat and pointed toward true north, as in the North Pole and the North Star. But not magnetic North, such as with a compass or smartphone, because here in the Triangle it will be 9 degrees farther left than true north due to magnetic declination. This is the considerable gap between the magnetic axis and the rotational axis of the earth, which can equate to about a month and an hour to a sundial.
Cut the tip of a toothpick to the length for the gnomon indicated and attach.
Level the sundial surface with a bubble level. Accuracy matters!2
Point the sundial to True North. (With a compass, True North will be 9° right/clockwise from Magnetic North.)
In March-October, subtract an hour to correct the 1 hour addition by Daylight Savings Time.
Accuracy is affected by the length and straightness of the gnomon, the levelness of the dial, and how close alignment is to True North. Please comment below or contact me if you can’t figure it out, I’m more than happy to help!
My sundial calculations were generated with the Sundial Program from the University of Oregon Solar Radiation Monitoring Laboratory.
Smartphone apps can work in a pinch, but a true level is more accurate. Same goes for the compass. I recommend the Swiss Army Knife on Android for the phone. Please send me an email or comment below to recommend a good one for iOS.